Suggestion:
well go to a store and purchase the wiring kit($30) , run the wiring from your car battery and back of your aftermarket stereo to the amp that is hooked up to the sub box. hope this kind of helps.
well go to a store and purchase the wiring kit($30) , run the wiring from your car battery and back of your aftermarket stereo to the amp that is hooked up to the sub box. hope this kind of helps.
{ 2 comments… read them below or add one }
Remember the correct inline fuse, the one close to the battery, the one that is suppose to save your butt incase of fire, if the powerwire gets hot enough.
4 Gauge Powerwire and same on groundwire. For amp upto 1000-2000watts.
2 Gauge if amp is 2001 W to 3000 W.
1 Gauge if amp is 3001 to 4000 W
0 Gauge for 4001 W and up to 6000 W.
If you got more than one amp, remember to put the numbers (Amphere on amps) together.
The wire from battery to fuse distribution block (if you have 2 amps in the system), needs to be bigger then. IE 2 Gauge, then after fuseDblock its 4 Gauge.
Im not good at explaining in english, but still i hope it helps you.
Besides, its better to asure you, reading online sizes to use etc.
u need a amp install kit. and depending if ur sherwood has rca outs in the back. if it does ur set if not. u need a line out converter(to go from Speaker level to rca). think u can get both for around $50 off ebay
You must log in to post a comment.